Pic. 11.23. Details for mounting the front door: 1, 2, 3 - gaskets
To install the back door, it is necessary to make three parts, 2 pieces each, in accordance with fig. 11.23.
Pic. 11.30. Mounting kit: 1 - pin for centering; 2 - bolts; 3 - fixed part of the loop; 4 - axis; 5 - moving part of the loop
When installing the front door, you need to purchase the mounting kit shown in fig. 11.30.
Install the back door in the following order:
- install the door on the support;
- install gaskets (see fig. 11.23) between the doorway and the door;
- install hinges 3 (see fig. 11.30) on the central rack;
- wrap, without tightening, bolts 2;
- install the door opposite the hinges;
Pic. 11.31. Hinge attachment: 1 - hinges
- tighten, without tightening, the hinge fastening bolts 1 (pic. 11.31) on the door;
- fix the limiter on the central rack;
Pic. 11.32. Checking gaps in the doorway: A, B - gaps
- close the door and check the gaps: gap A (pic. 11.32) height should be (5±2) mm, clearance B — (4±1,5) mm;
- open the front door;
- keep the tailgate closed;
Pic. 11.33. Door closing check: 1 - holes; 2 - locating pins; 3 - pin; 4 - bolts
- tighten bolts 4 (pic. 11.33);
- fix the limiter on the central rack;
- check the gaps around the perimeter of the door;
- if the door is difficult to close, do the following: place pin 3 for centering on the door hinge, if necessary, bore holes 1 for dowel pins 2 or grind dowel pins 2;
- check the gaps around the perimeter of the door;
- finally tighten the hinge bolts.