Removal and installation of rear drum brake shoes BOSCH (Peugeot 206)

Note. The pads must be replaced on both sides.

Remove the brake pads in the following order:

• turn on 1st gear and set the stops under the wheels;
• raise the rear of the car;
• remove the wheel;
• remove the drum with the hub;

• remove lower spring 1 (pic. 9.15);

• remove cups 2 (pic. 9.16) springs by turning them 90°;
• remove the upper ends of the blocks from the wheel cylinder. Remove the pads, the spacer bar of the automatic gap adjustment mechanism and the spring;

• secure the wheel cylinder pistons against falling out using tool 1 (pic. 9.17);

Attention! Be careful not to damage the protective covers of the wheel cylinder.

• disconnect the parking brake cable from the block;
• check the tightness of the wheel cylinder, the condition of its protective covers, the wear of the drum;
• if necessary, replace the wheel cylinder and drum.

Install the brake pads in the following order:

• clean the brake shield from dust and dirt;

• replace O-ring 1 (pic. 9.18);
• on surface A, apply a thin layer of lubricant type LUBRITHERM G200;
• lubricate the parking brake lever drive axle;

• lubricate the threads of the stud 2 (pic. 9.19) gap regulator;
• screw the adjusting wheel 1 onto the stud so that there is a small distance between the wheel and the stud shoulder;
• set the automatic gap adjustment knob to position A;

• continue further installation in the reverse order of removal, while tightening nut 1 (pic. 9.20) fastening the hub to the drum;
• torque of 200 Nm and lock nut 1 using the tool;
• remove air from the hydraulic brake system;
• with the engine running with great force, smoothly and continuously press the brake pedal several times;
• reinstall the wheel by tightening the bolts to a torque of 85 Nm;
• lower the back of the car;
• adjust the parking brake.