Removing
Note. Depending on the equipment variant, an outside temperature sensor can be installed in the exterior mirror housing on the right side.
Disconnect the turn signal repeater lamp (2) from the base of the lid (1) (in the zone «A»).
Remove the turn signal repeater lamp (2).
Detach the shroud (3) (in the zone «IN») and remove.
Detach the inner cover of the base (4) (in the zone «WITH») and remove.
Detach the inner cover (5) (in the zone «D») and remove.
Remove the outdoor temperature sensor (depending on equipment variant).
Adjust the mirror glass (7) to the lowest position.
Insert your hand behind the exterior mirror glass and remove the retaining tabs (6).
Remove the glass from the exterior mirror housing.
Disconnect electrical connections (8) (depending on equipment variant).
Slide and remove base seal (9).
Loosen the screws (10) electric motor (11) outside mirror glass drive.
Pull motor (11).
Disconnect the connector using a thin screwdriver (12), by unfastening one by one the paws (13), holding the 6 electric motor (11).
Remove the electric motor 11.
Remove the wiring harness (14) outside mirror frame.
Cut the black wires of the outdoor temperature sensor (15) (in the zone «E»).
Remove the outdoor temperature sensor.
Installation
Repair the outdoor air temperature sensor circuit with hot melt bushings (type «RAYCHEM»), then insulate with hot-melt sheaths.
Install the parts in reverse order.
Check the operation of the outside mirror.