Note. Use one of the following tools to adjust:
- - «Facom LUX 200L»;
- - «Muller 664»;
- - «Laser Tecnotest 432/PM».
Preliminary Operations
Unload the vehicle.
The vehicle must be in running order.
Remove accumulations of dirt, snow or ice as they may affect the operating height of the vehicle. Check tire pressure.
Inflate the tire to the amount recommended by the manufacturer for normal driving conditions.
Park the car on a level surface with the wheels straight ahead. Turn on the headlights.
Check the operation of the load corrector by turning the knob.
Set it to normal load position «0».
Check the operation of the automatic headlight beam height adjustments by turning on the headlights, pressing on the rear of the vehicle and checking that the beams are stable (depending on configuration).
Examination (headlight with halogen lamp)
Start the engine.
Align the headlight adjuster with the vehicle (depending on the type of headlight control).
Line up the center of the headlight regulator lens and the optical center of the headlight (in the zone «A»).
Turn on the low beam headlight.
Proceed with the test procedure in accordance with the headlamp adjuster instruction manual.
Examination (headlight with xenon lamp)
Start the engine.
Align the headlight adjuster with the vehicle (depending on the type of headlight control).
Line up the center of the headlight regulator lens and the optical center of the headlight (in the zone «b»).
Turn on the low beam headlight.
Proceed with the test procedure in accordance with the headlamp adjuster instruction manual.
Adjustment
Adjust the headlight adjuster in accordance with the accessory's instruction manual.
Determine the amount of inclination of the headlight beam in the area «b».
Adjust the found value (depending on headlamp control).
Adjustment method (headlight with halogen lamp)
Adjust the vertical headlight adjustment (beam height) with a screw in the area «e».
Adjust headlight leveling (azimuth) with a screw in the zone «d».
Adjustment method (headlight with xenon lamp)
Adjust the vertical headlight adjustment (beam height) with a screw in the area «g».
Adjust headlight leveling (azimuth) with a screw in the area «f».
Direct the light beam «h» headlights slightly below the marking line «j».
Note. When adjusting the dipped beam headlight, the high beam headlight is automatically adjusted.