Initialization
Unlocking and locking the car locks is not possible after disconnecting the battery, replacing the battery or in case of malfunctions of the remote control. For its further work it is necessary to carry out initialization. Switch off the ignition.
Turn the key to position 2.
Immediately press the lock button for a few seconds.
Switch off the ignition and remove the key from the lock.
The remote control is then ready for use again.
Battery replacement
Note. The remote control uses a battery with the article number CR1620/3 volts.
A depleted battery is signaled by the PIK01 alarm, a buzzer and a message on the multifunction display.
Use a coin or a flathead screwdriver to pry open the remote's case. Remove the old element from the slot. Insert a new battery into the socket with the same polarity.
Close the case of the remote control and carry out its initialization.