Removing
Attention. After turning off the ignition, wait 15 minutes before disconnecting the battery to ensure that the trip computer and ECU settings are remembered.
Disconnect the battery.
Raise and secure the vehicle on a lift.
Remove the protective shield under the engine.
Disconnect the connector in the area «A».
Remove the oil level and temperature sensor (1) and remove the gasket (2).
Installation
Attention. Be sure to replace the gasket (2).
Install a new gasket and oil level and temperature sensor, tighten to 27 Nm. Connect the connector in the zone «A». Install protection under the engine. Connect the battery.