Attention. Install plugs on the inlets and outlets of the air filter.
Remove the air deflector (3).
Remove the air intake resonator (4).
unscrew the bolt (1) and remove the air intake (2).
Move up the wire harness groove (6).
Disconnect the oil pressure sensor connector (5) (in the zone «A»).
Note. When removing, use a rag to protect the engine from oil escaping from the hole.
Using a 22mm long socket, remove the oil pressure sensor (5).
Install the previously used oil pressure sensor seal (5) on the oil pressure tap extension 1503-M [2].
Install the extension in place of the oil pressure sensor.
Unscrew the tip [A] from the oil pressure tap.
Install the oil pressure tap [O] on the extension [2].
Connect a pressure gauge to the oil pressure tap [O]. Remove the plugs.
Install the air inlet (2).
Start the engine.
Note. Checking the engine oil pressure is carried out on a hot engine after checking the oil level.
Compare the read values with the data given in the table «Data for checking the lubrication system (all engines)».
Note. Work on the engine only if the measured values are below the values given in the table.
Remove all fixtures.
Attention. When reinstalling, all removed seals must be replaced with new ones.
Install the oil pressure gauge (5) and connect its connector in the zone «A».
Install the harness groove (6). Remove the plugs.
Reinstall previously removed components.
Top up the engine oil level if necessary.