Attention. Use only new, non-emulsified brake fluid, do not allow hydraulic circuit contamination.
Attach transparent tube (6) on the bleeder valve (in the zone «f»).
Dip the end of the tube into a container of brake fluid below the level of the clutch slave cylinder.
With a transparent tube (6) create a bend «e», as it shown on the picture.
Attention. end of tube (6) must be immersed in a vessel with brake fluid.
Loosen the drain bolt (in the zone «f»).
Note. Turn away the union for simplification of an outflow of a brake liquid in a vessel.
Fully depress the clutch pedal seven times by hand and quickly move back.
Let the clutch pedal return to the up position.
Fill the reservoir with brake fluid to the maximum level.
Loosen the drain bolt (in the zone «f»).
Fully depress the clutch pedal seven times by hand and quickly move back.
Leave the clutch pedal in the down position for the last drive.
Close the bleed screw (in the zone «f»).
Repeat if necessary.
Top up the brake fluid level in the reservoir to the level «Max».
Quickly depress and release the clutch pedal 40 times.
Start the engine.
Apply the parking brake.
Turn on transmission.
Check that the start of slippage in the clutch appears during the course (X) not less than 45 mm (size «X» provided for reference).
Repeat pumping operations (if necessary).