2. Unscrew the lock button (see photo).
3. Carefully pry off the cover of the door latch release handle and remove it (see photo).
4. Press back the plastic washer behind the power window handle and use a hooked wire to remove the fixing clip from the handle. Remove handle and washer (see photo).
5. Unscrew and remove the Phillips screw securing the front of the armrest. Remove 2 screws under the armrest. Remove armrest (see pictures).
 |  |
6. Insert a screwdriver with a wide blade (or a dull knife) under the door trim and press down on it to release the plastic clips holding the trim to the door. Run along the edge of the skin until all clips are released and remove the skin (see photo).
7. Installation of the casing is carried out in the reverse order. Snap the trim clips into place. Before installing the power window handle, install the fixing clip on it (see photo) and puck. Check the position of the handle: with the door closed and the glass up, it should not touch the knees of the person sitting in the chair.
