- remove the gearbox;
- remove the differential box;
Pic. 5.41. Using the universal puller FACOM U53 K2 (1) to remove bearings (2) from differential box
- using the universal puller FACOM U53 K2 1 (pic. 5.41), remove the bearings 2 from the differential box;
Pic. 5.42. Differential: 1 - locking pin; 2 - persistent cups; 3 - satellites; 4 - axis; 5 - planetary gears; 6 - centering sleeve
- knock out the locking pin 1 of the axle 4 (pic. 5.42) satellites;
- remove the axle 4 satellites;
- turning, remove satellites 3 and thrust cups 2 from the differential box;
- from the side opposite to the driven gear, remove the centering sleeve 6;
Attention! It is forbidden to disconnect the satellites from the thrust cups, as well as the gears of the drive shafts from their friction washers.
- unscrew the bolts and remove the driven gear.
Install the differential box as follows:
- using a special tool, install the bearings on the differential box;
- install the axis of satellites, satellites and thrust cups, after turning them;
- install planetary gears;
- on the side opposite the driven gear, install the centering sleeve;
- fix the axis of the satellites with new locking pins;
- install and secure the driven gear with new bolts, tightening them crosswise to a preliminary torque of 20 Nm and finally to a torque of 60 Nm.