Removing
1. Raise the rear of the car and remove the wheels.
2. Remove the shock absorber from the corresponding side.
3. Remove stabilizer and torsion bar.
4. Disconnect the brake line at the bracket with the brake line.
5. At the cable connector, loosen the handbrake cable and disconnect the front cable from the rear.
6. Remove the rear cable from the passages in the rear suspension beam holders.
7. Remove lever.
8. In the case of replacing the lever with a new one, drill a small hole in the cover of the axle of the suspension lever.
Installation
1. Check the condition of the lever, bearings, o-rings and the connection surface of the lever and cross member.
2. Install the lever on the axle.
3. Connect the handbrake cable.
4. Connect the brake line.
5. Install torsion bars and stabilizer.
6. Remove air from the brake system.
7. Install the wheels and put the car on them.