Engine mount brackets
1 - right bracket, 2 - right elastic cushion, 3 - middle bracket, 4 - left elastic cushion, 5 - bottom bracket, 6 - clamp
1. Drain the coolant from the cooling system.
2. Drain the oil from the gearbox and engine.
3. Remove the engine bottom bracket clamp (1 - bottom bracket bracket).
4. Disconnect the exhaust pipe.
5. Disconnect the stabilizer from the arms.
6. Remove the ball joint of the lower suspension arm from the steering knuckle.
7. Remove the right drive shaft.
8. Remove the left drive shaft from the differential (without removing it from the hub).
9. Remove the battery.
10. Remove the battery bracket along with the fuel filter.
11. Remove the air filter with housing.
12. On XUD 9 engines, remove the suction plug.
13. On XUD 7TE engines, remove the turbocharger and disconnect the horizontal travel stop from the upper right engine bracket (1 - limiter).
14. Disconnect the connection element and wires.
15. Remove the power steering pump without disconnecting it.
16. Remove the radiator.
17. Use a special lifting device with two hooks. Position the hooks so that the engine is tilted slightly towards the gearbox side when lifting.
18. On XUD 7TE engines, remove the travel stop.
19. Unscrew the nut of the upper right engine bracket from the elastic cushion.
20. Support the gearbox with a jack.
21. Remove the gearbox bracket.
22. Raise the engine and remove the right engine bracket (1 - right bracket nut).
23. Lower the jack and turn the engine clockwise.
24. Remove the engine from above.