Differential
1 - sealing ring, 2 - adjusting gasket, 3 - bearings, 4 - differential box, 5 - final drive wheel, 6 - sealing ring, 7 - pinion axle, 8 - pin for fastening the pinion axle, 9 - gear centering gasket
Knocking out the pin of the axis of the satellites
Removing the bearing from the differential case
1. Knock out pin of fastening of an axis of satellites, and then to remove an axis and satellites.
2. Remove main gear. Remove the bearings from the differential case using a universal puller.
3. Replace the bearings with new ones using tool 80317 D and a press.
4. Install the gears, and then the device that holds the gears from falling out. The figure shows the installation of satellites with new slip rings.
5. Install the final drive gear. The chamfer of the final drive gear must be on the side of the differential box. Bolts should be tightened to 65 Nm.