Drive Shafts — Design Description View of the front suspension with drive shafts and steering system Drive shafts 1 - connecting shaft of the right drive shaft, 2 - right drive shaft, 3 - external hinges, 4 - internal hinges, 5 - left drive shaft, 6 -...
Specifications of drive shafts The transmission of traction to the wheels is provided by two drive shafts of different lengths. Each shaft has two hinges. On the gearbox side, a JB 2 three-arm joint is installed, and on the wheel side, a ball joint....
Removing drive shafts Attention! A new nut must be used when installing the lower arm ball joint. Hub blocking with forks 0606 AY 1. The car must be on wheels. On the corresponding side, unscrew the bolt securing the stabilizer link to the...
Installing the drive shaft Clean drive shaft splines in hub and gearbox. Apply a thin film of grease to the sealing lips, drive shaft splines and flanges. Left drive shaft 1. Install the drive shaft into the differential, aligning the splines of...
Replacement of covers of hinges of equal angular speeds External hinge Plastic rings located on the outside of the protective case Removing 1. Remove drive shaft. Models with 1.4 liter engine 2. Remove the inner joint from the drive shaft. 3. Fix the drive shaft in a vice...
Replacing the intermediate bearing of the right drive shaft Attention! To remove the bearing, you must use a special puller. 1. Remove right drive shaft. 2. Check the condition of the bearing, which should rotate easily and evenly and should not have play between the inner and...
Rear wheel drive with 4x4 powertrain The removal and installation of the drive axle is not laborious. Tightening torques must be observed. Removal and installation of a power shaft 1. Raise the corresponding side of the vehicle and drain the oil from the...