Washer reservoir
1. The windshield washer reservoir is located behind the right front fender. In the engine compartment, remove the filler cap and unscrew the filler neck from the washer reservoir (neck fastening nut is indicated by an arrow).
2. Raise the front of the car and secure it on stands. Remove the right front wheel. Unscrew the screws and remove the wheel arch insert.
3. Drain the fluid from the tank, for which remove the rubber plug at the base of the tank. After the liquid flows out of the tank, reinstall the plug.
4. Loosen the clamps and disconnect the hoses (1) from the washer pump. Disconnect the electrical connector (2) from the washer pump and fluid level sensor.
5. unscrew the bolt (indicated by an arrow) securing the top of the tank and remove the tank.
Attention! Due to limited space to unscrew the reservoir bolt, it may be necessary to remove the headlight.
6. Installation is made in sequence, return to removal.
Washer pump
7. Disconnect the electrical connector and fluid hose from the pump. Drain the fluid from the tank.
8. Separate the pump from the tank and remove the sealing ring.
9. Installation is made in sequence, return to removal. Install a new pump o-ring.
Washer fluid level sensor
10. Raise the front of the car and secure it on stands. Remove the right front wheel. Unscrew the screws and remove the wheel arch insert.
11. Disconnect the electrical connector from the fluid level sensor in the washer reservoir and remove the sensor from the reservoir. Remove the sealing ring.
12. Installation is made in sequence, return to removal. Install a new sensor o-ring.
Windshield washers
13. Open the hood and disconnect the hoses from the windshield washer. Press the mounting brackets and remove the washer from the hood.
14. Installation is made in sequence, return to removal. Check the direction of the fluid jet supplied by the washer nozzle onto the windshield.
Rear door washer
15. Open the tailgate, unscrew the screws and remove the spoiler from the top of the tailgate.
16. Disconnect the washer hose and remove it from the spoiler.
17. Installation is made in sequence, return to removal.
Headlight washer
18. Remove the front bumper.
19. Disconnect the hose from the washer, unscrew the fastening screws and remove the headlight washer from the bumper.
20. Installation is made in sequence, return to removal.