Front wheel brake caliper
1. Jack up the front of the car, place it on jack stands, remove the corresponding front wheel.
2. Disconnect hose 1 from brake line 2 (see illustration). Plug the holes with suitable plugs.
5.2 Disconnect hose 1 from brake line 2
3. Remove U-clip 3 (see illustration 5.2). The clamp needs to be replaced.
4. Disconnect the plug of the brake pad wear sensor.
5. Disconnect the brake hose 1, unscrew the bolts 4 and remove the caliper 5 (see illustration).
5.5 Disconnect the brake hose 1, unscrew the bolts 4 and remove the caliper 5
Attention! Do not unscrew bolt 6 (see illustration 5.5).
Rear wheel brake caliper
6. Jack up the rear of the vehicle, place it on jack stands, and remove the appropriate rear wheel.
7. Disconnect the brake hose 1 at point A (see illustration). Plug the holes with suitable plugs.
5.7 Disconnect the brake hose 1 at point A
8. Remove U-clip 2 (see illustration 5.7). The clamp needs to be replaced.
9. Disconnect the brake pad wear sensor plug.
10. Disconnect the brake hose 1 from the caliper (see illustration).
5.10 Disconnect the brake hose 1 from the caliper
11. Remove the protective cap and unscrew the bolt 3 (see illustration 5.10).
12. Unscrew the bolt 4 and remove the caliper 5 (see illustration 5.10).
Install the wheel brake caliper in the reverse order of removal, taking into account the following:
13. Clean the threads of the caliper mounting bolts and apply a thin coat of Loctite Frenetanch.
14. Tightening torque of bolts 4 fastening the brake caliper of the front wheel (see illustration 5.5) is 110 Nm.
15. The tightening torque of bolt 3 of the rear wheel brake caliper is 50 Nm, bolt 4 is 27 Nm (see illustration 5.10).