2. Remove slider 1 and bracket 2 of the plug (see illustration).
6.2 Remove slider 1 and bracket 2 of the plug
3. Disconnect the brake hoses 3 from the master brake cylinder (see illustration 6.2).
4. Unscrew bolts 5 (see illustration 6.2).
5. Disconnect the brake hoses 4 (see illustration).
6.5 Disconnect the brake hoses 4
6. Release from fastenings and displace the main brake cylinder 6 (see illustration 6.5) away from the place of work.
7. Disconnect the low pressure hose 7 from the vacuum brake booster (see illustration 6.5).
8. Remove the wiper arms and the fairing grille by unscrewing the top 8 and bottom 9 bolts of its fastening (see illustrations 6.8 and 6.8a).
6.8 Unscrew the upper bolts 8 of the fairing grille
6.8a Unscrew the lower bolts 9 for fastening the fairing grille
9. Remove the lower overlay under the instrument panel on the driver's side.
10. Remove the brake pedal from axle 10 (see illustration).
6.10 Remove the brake pedal from axle 10
11. Remove the brake booster from the bracket to gain access to clip 11, and then remove the clip (see illustration).
6.11 Remove clamp 11
12. Remove the protective cover 12 (see illustration).
6.12 Remove the protective cover 12
13. Unscrew four bolts 1З and remove bracket 14 (see illustration 6.13),
14. Remove the vacuum booster 15 of the brake drive (see illustration).
6.14 Remove the vacuum booster 15 of the brake drive
The brake booster is installed in the reverse order of removal, taking into account the following:
15. Make sure you have the rubber bushing 16 (see illustration).
6.15 Make sure that the rubber bushing 16 is present