17. Clips 1 and 2 (see illustrations 2.3 and 2.12) must be replaced after each disassembly.
18. Make sure the sound deadening pad 1 is installed properly (see illustration).
2.18 Make sure the soundproofing strip 1 is installed properly
19. The tightening torque of the nuts securing the shift lever housing is 7 Nm.
20. Tightening torque of stop bolts 3 (see illustration 2.12) is 20 Nm.
Gear lever knob
21. Wrap the head 2 of the gear lever 1 with a clean rag and remove the head with pliers, after loosening its fit (see illustration).
2.21 Wrap the head 2 of the gear lever 1 with a clean rag and remove the head with pliers after loosening its fit
22. Clean the contact surfaces of head 2 and shift lever 3 with a sponge dampened with soapy water (see illustration 2.21).
23. Install the shift lever knob in its seat by gently pushing it down.
Attention! Do not hammer the shift lever head with a hammer to avoid damage to the lever.