The on-board computer informs the driver about five parameters. This information is displayed at the top of the instrument panel.
- air temperature
- current fuel consumption
- average fuel consumption
- average speed
- distance that a vehicle can travel with the available fuel
In order to display the relevant information on the on-board computer, press the button on the end of the windshield wiper stalk switch.
Outside temperature
The outside temperature message appears as soon as the ignition is switched on. If the°C symbol flashes at the same time, then the computer reports ice.
Current fuel consumption
The current fuel consumption is calculated from the fuel consumption of the last two seconds before the message is displayed on the instrument panel. The fuel consumption message is currently displayed on the instrument panel only when the vehicle reaches a speed of 20 km/h.
Average fuel consumption
The average fuel consumption is calculated from the amount of fuel consumed per distance traveled since the last «zeroing» computer readings.
Average speed
The average speed is calculated as the mileage for a certain operating time (with the ignition on) since the last time the computer was reset.
The distance that the car can travel on the available fuel supply
The distance that the vehicle can travel with the available fuel is calculated from the fuel consumption during the last 10 minutes. If there is less than 3 liters of fuel left in the tank, then three segments appear on the dashboard instead of the readings. To reset the trip computer, hold down the button on the end of the windshield wiper switch for about three seconds. Each time the ignition is switched on, an outside temperature message is displayed. If the battery was disconnected, then when the ignition is turned on after it is installed, all messages and symbols are displayed on the display. When the button is pressed, the on-board computer is activated and a message about the outside temperature is displayed on the display. If during a trip segments appear on the display instead of the numbers of the corresponding message, then you need to contact the workshop.
Switching on the headlights and lighting lamps
If the switch is set to position 0, the lighting will be turned off. To do this, just turn the rotating gear on the switch up.
Parking light switch
Turn the rotating gear on the switch up to turn it on. If an acoustic signal is heard when one of the doors is opened, this means that the lighting is not turned off.
Horn switch
To sound the horn, press the button at the end of the steering column switch.
Light switch
The light signal can be given when the lighting is off, when the parking light is on, or when the dipped beam is on. To do this, it is enough to pull the stalk switch towards you until you feel resistance, but without allowing switching. A light signal can also be given when the ignition is off.
Turn signal switch
To turn on the left turn indicator, push the stalk switch down. To turn on the right turn indicator, move the stalk switch lever up.
Fog light switch
When the fog lamp switch is pressed, the control lamp lights up. Fog lamps turn on only when the parking light is on, the dipped beam headlights are on, or the high beam headlights are on.
Rear fog light switch
When the fog light switch is pressed, the warning light comes on. The fog lamps will only come on when the dipped beam or high beam headlights are on, or with fog lamps. An additional control lamp also lights up on the instrument panel.
Hazard light switch
When this switch is pressed, the red control lamps and indicator lamps flash. All four direction indicators work simultaneously in intermittent mode. The light emergency signaling joins also at the switched-off ignition.
Front window wiper switch
3. accelerated glass cleaner
2. normal operation of the glass cleaner
1. Intermittent glass cleaner
0. off
4. short-term operation of the glass cleaner
Rear window wiper switch
1st position = off
2. position = interval operation
3. position = wiper and washer operation
Rear defroster switch
This switch heats the rear window and side mirrors. Turning on the heater is confirmed by a corresponding control lamp. The heated rear window switches off automatically after 12 minutes to avoid increased power consumption. Switching off of heating of back glass is made by repeated pressing the switch.