Car steering Peugeot Partner 1

Steering wheel — removal and installation
Models without airbag Removing 1. Set the front wheels to position «straight ahead» and unlock the steering column by inserting the key into the ignition switch. 2. Carefully remove the trim from the steering wheel hub....

Steering column — removal, inspection and installation
Note. If applicable, install with a new nut and bolt securing the intermediate shaft to the steering gear. Removing 1. Disconnect the wire «masses» from battery (see « Disconnecting the battery »). 2. Remove the...

Ignition switch / steering column lock — removal and installation
Removing 1. Disconnect the wire «masses» from battery (see « Disconnecting the battery »). 2. Remove the fuse box cover and the lower section of the front panel on the driver's side. Remove the upper and lower steering...

Steering gear assembly — removal, repair and installation
Note. All nuts disturbed during removal must be replaced without fail. This is due to the fact that the threads of these nuts are coated with a compound to lock the threaded connections (designed for one puff only)....

Power Steering System — Bleeding
1. This procedure is required only after any part of the hydraulic system has been disconnected. 2. Remove the filler cap of the booster reservoir and add the prescribed fluid up to the MAX mark on the side of the...

Power steering pump — removal and installation
Removing 1. The power steering pump is mounted on the front side of the engine. 2. Remove the accessory drive belt as described in the relevant part chapter 1 . 3. On later models with a diesel engine, release the four...

Tie rod end — removal and installation
Note. At installation it is necessary to use a new nut of fastening of a spherical joint of steering draft to a rotary fist. Removing 1. Apply the parking brake. Raise the front of the vehicle and securely jack stands...

Wheel alignment — general information
General information 1. Steering installation and suspension geometry are defined by four reference angles. All angles are expressed in degrees. The axis of rotation of the wheel is defined as an imaginary line passing...