Withdrawal (engines 1.4 l)
Ignition coil mounted on the cylinder head
1. The ignition coil is mounted on the left end of the cylinder head.
2. Disconnect the wire «masses» from battery (see «Disconnecting the battery»), then press the clip and disconnect the ignition coil electrical connector (pic. 3.2).
Pic. 3.2. Disconnecting the electrical connector of the ignition coil
3. Mark the position of the high voltage wires, and then disconnect them from the coil terminals (pic. 3.3).
Pic. 3.3. Disconnect the high voltage wires from the coil terminals
4. Remove the four screws securing the coil to the appropriate support bracket and remove the coil from the engine compartment (pic. 3.4).
Pic. 3.4. Remove the four screws and remove the ignition coil from the support bracket
Ignition coil pack mounted above the spark plugs
5. Disconnect the wire «masses» from battery (see «Disconnecting the battery»).
6. Disconnect the engine breather hose quick couplers at the air filter intake duct, cylinder head cover, and intake manifold (pic. 3.6, a-c). Move the hose to the side.
Pic. 3.6, a. Disconnect the engine breather hose at the air filter intake air line...
Pic. 3.6b....cylinder head cover (connection is marked with an arrow)...
Pic. 3.6, c....and intake manifold (connection is marked with an arrow)
7. Disconnect the electrical connector on top of the ignition coil pack (pic. 3.7).
Pic. 3.7. Disconnect the electrical connector on the top of the ignition coil pack
8. If applicable, loosen the nut and remove the RFI along with the appropriate support bracket from the right end of the coil pack (pic. 3.8, a, b).
Pic. 3.8, a. Remove the RFI suppressor from the right end of the coil pack...
Pic. 3.8b....together with the appropriate support bracket
9. Turn away a nut of fastening of each end of the block of coils of ignition on basic hairpins. Keep in mind that the stud may come out with the nut.
10. Lift the ignition coil pack off the support studs while carefully separating the high voltage connectors from the top ends of the spark plugs. Remove the block from the candles and remove it from the engine compartment (pic. 3.10).
Pic. 3.10. Remove the ignition coil unit from the support studs
Withdrawal (engines 1.6 l)
11. Turn out six screws and remove a plastic cover of the block of coils from the top part of the engine between two covers of a head of cylinders.
12. Disconnect the electrical connector at the left end of the ignition coil pack (pic. 3.12).
Pic. 3.12. Disconnect the electrical connector on the ignition coils (marked with arrows)
13. Press the clips and remove the two breather pipes from the area between the cylinder head covers (pic. 3.13).
Pic. 3.13. Press the clips and disconnect the breather pipes
14. Turn out four screws of fastening of the block of coils of ignition (pic. 3.14).
3.14. Remove the screws securing the coil unit
15. Lift the ignition coil pack and remove, while carefully separating the high voltage connectors from the top ends of the spark plugs. Remove the block from the candles and remove it from the engine compartment.